SCHUNK GSM-Z 38, Сборка и руководство по эксплуатации

Страница: 43 / 60

Maintenance
9. Clean all parts thoroughly and check them for defects and
wear.
10. Replace the seals included in the sealing kit.
Assembly
Observe the permissible screw tightening torques and the greases
and adhesives to be used for the assembly (
Screw tightening
torques [
}
41] and Grease/greasing areas [
}
40]).
1. Grease the seal (24) and O-ring (23) and mount them on the
cover housing (11).
2. Grease the guide grooves in the cover housing (11).
3. Grease the running surfaces of the base jaws (3a and 3b).
4. Grease the piston rod (4) in the diagonal pull area, separately
from the lower part of the piston rod (4) ( Grease/greasing
areas [
}
40]).
5. Push the base jaws (3a and 3b) into the cover housing (11) and
insert the piston rod (4) in the cover housing (11) from above.
Insert the diagonal pull of the piston rod in the grooves of the
base jaws.
6. Fasten the cover (8) to the cover housing using the screws (20).
7. Grease the seals (25) and mount them on the piston (39).
8. Fasten the piston (39) to the piston rod using the screws (19).
9. Glue the magnet into the piston
Mounting orientation of the
magnets, item 120 [
}
45].
10. Carefully fit the cover housing (11) with the mounted parts
into the bushing (44).
11. Screw the cover housing (11) into the bushing (44) using the
screws (111).
8.6.2 Version with maintenance of gripping force unit
WARNING
Risk of injury due to spring forces
With the "O.D. gripping" version, the bushing (44) or cover
housing (11) is under spring tension.
WARNING
Risk of injury due to spring forces
With the "I.D. gripping" version, the piston (36) is under spring
tension.
43 06.00 | GSM-Z | Assembly and Operating Manual | en | 389110