SCHUNK GSM-P 32, Сборка и руководство по эксплуатации

Страница: 24 / 60

Assembly
24 11.00 | GSM-P | Assembly and Operating Manual | en | 389104
"A" - "D" are main connections, "a" - "d" are direct connections
Connection Function
Hose connection A Swivel toward 180° or 90°
position
Hose-free direct connection a
Hose connection B
Swivel toward 0° position
Hose-free direct connection b
Hose connection C
Move gripper into »OPEN«
position
Hose-free direct connection c
Hose connection D
Move gripper into »CLOSED«
position
Hose-free direct connection d
Connections “C” and “D” for the modules with a base cross section
of 25x25 are slightly offset from center
If direct connections "a" – "d" are used, use the locking screws
included in the accessory pack for the corresponding main
connections "A" – "D".
If air connections "a" – "d" are used, ensure sufficient throttling,
which can be set by means of exhaust air throttling. To do this, the
throttle reductions for the main connections, which are designed
for a medium load, can be attached to the adapter plate, for
example.
• Open only the air connections that are needed.
• Close unused main air connections using the screw plugs from
the enclosed pack.
• For a hose-free direction connection, use the O-rings from the
enclosed pack.
5.3 Mounting the sensor
NOTE
Observe the assembly and operating manual of the sensor for
mounting and connecting.
The product is prepared for the use of sensors.
• For the exact type designations of suitable sensors, please see
catalog datasheet and Overview of sensors [
}
25].
• For technical data for the suitable sensors, see assembly and
operating manual and catalog datasheet.
– The assembly and operating manual and catalog datasheet
are included in the scope of delivery for the sensors and are
available at schunk.com.
• Information on handling sensors is available at schunk.com or
from SCHUNK contact persons.