Operation
6 Operation
6.1 Basic information
WARNING
Risk of injury when the product is rotating, due to the possibility
of parts flying off!
•
Do not exceed the maximum permissible clamping force.
•
Make sure that the clamping pins are mounted and seated
correctly.
•
Ensure that the flat areas or clamping pins are in full contact
with the chuck jaws.
•
Remove the locking pins before turning.
•
Take suitable protective measures to secure the danger zones.
•
Wear suitable protective equipment.
WARNING
Danger of crushing, impact and cutting when clamping and
unclamping the product!
•
When clamping and unclamping the product, do not reach
between the product and the chuck jaws.
•
Prevent unintentional actuation of the lathe chuck.
•
Remove sharp edges on the chuck jaws after turning.
•
Wear suitable protective equipment, especially gloves.
NOTICE
Possible material damage due to incorrect loading of the
clamping pins.
If the clamping pins are loaded laterally, they can be damaged or
sheared off.
•
Ensure that the clamping pins are in full contact with the
chuck jaws.
•
Do not load the clamping pins laterally.
25
02.00 | Jaw turning rings | Assembly and Operating Manual | en | 0189701
