background image

• 5 • 

The SA1471 charges small batteries and maintains large 12 volt batteries, keeping them at full charge. However, if you were to use this unit to charge a large battery, you 

may lose some of the battery’s capacity. This would cause the battery to be unable to hold a charge and become useless. 

NOTE: The maintain mode technology allows you to safely maintain a healthy battery for extended periods of time. However, problems with the battery, electrical problems 

in the vehicle, improper connections or other unanticipated conditions could cause excessive current draws. As such, occasionally monitoring your battery and the 

maintaining process is recommended.

NOTE: This is a manual charger and will overcharge a battery if permitted to operate for extended periods of time. Monitor charging often, as not doing so may cause 

damage to your battery, or result in other property damage or personal injury.

WARNING: The manufacturer strongly recommends using a solar charge controller (p/n 940261073, not included) in tandem with this solar panel for optimal results, and 

to avoid overcharge or discharge of the battery.
USING THE QUICK-CONNECT CABLE ASSEMBLIES

Connect either of the two output cable assemblies to the solar panel. Do not place on wet ground, anywhere it could be accidently stepped on or in a place or position 

where it could fall while being used. Never use the output cables together or for other applications, as reverse polarity and/or overcharge conditions will occur.
50 AMP BATTERY CLIP CABLE ASSEMBLY 

1.  Connect the end of the solar panel output cable to the end of the 50 amp battery clips cable. 

2.  Follow the steps in sections 6 and 7 to connect the output clips to the battery. 

3.  After a good electrical connection is made to the battery, place the solar panel in the sun, per the instructions in step 4 of the Solar Panel Location section. 
12V ACCESSORY PLUG CABLE ASSEMBLY

Maintain or charge your battery without lifting the hood. 

1.  Connect the end of the 12V accessory plug cable to the solar panel.

2.  Insert the 12V accessory plug into the 12V accessory outlet.

3.  Route the power cord from the solar panel through the vehicle’s open window.

4.  Place the solar panel in the sun, per the instructions in step 4 of the Solar Panel Location section. 

11.  MAINTENANCE INSTRUCTIONS

11.1  After use and before performing maintenance, unplug and disconnect the solar panel (see sections 6, 7 and 8).

11.2  Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips, cords and the solar panel.

11.3  The solar panel uses a glass substrate; handle with care.

11.4  Always keep the glass surface clean using a soft cloth in order to ensure its maximum output.

11.5  Ensure that all of the solar panel components are in place and in good working condition, for example, the plastic boots on the battery clips.

11.6  Servicing does not require opening the unit, as there are no user-serviceable parts.

11.7  All other servicing should be performed by qualified service personnel.

12.  MOVING AND STORAGE INSTRUCTIONS

12.1  Store the solar panel unplugged, in an upright position. 

12.2  Store inside, in a cool, dry place.

12.3  Do not store the clips clipped together, on or around metal, or clipped to cables. 

12.4  If the solar panel is moved around the shop or transported to another location, take care to avoid/prevent damage to the cords, clips and solar panel. Failure to do so could 

result in personal injury or property damage.

13.  SPECIFICATIONS

Peak power output .....................................................................................................................4.8 Watts
Tested under standard conditions .................................................................. AM1.5, 100mW/cm

2

, 25°C

Optimum working voltage ............................................................................................................ 17.50 V
Optimum working current ............................................................................................................. 260 mA
Operating temperature ............................................................................. -40° F–185° F (-40° C–85° C)

14.  ACCESSORIES

Solar charge controller ............................................................................................................940261073

15.  BEFORE RETURNING FOR REPAIRS

For REPAIRS OR RETURNS, visit 365rma.com
Visit batterychargers.com for Replacement Parts.

16.  LIMITED WARRANTY

For information on our one year limited warranty, please visit batterychargers.com or call 1-800-621-5485 to request a copy.
Go to batterychargers.com to register your product online. 

Schumacher

®

 is a registered trademark of Schumacher Electric Corporation.

Содержание SA1471












Отзывы: