3
Safety
3.7
Residual risks
16
/80
Table saw BS-350 LST, BS-400 LST-E230, BS-400 LST-E400, BS-500 LST
3.7
Residual risks
Hazard and notice signs
The machine was subjected to a risk assessment. The identified hazards
were, as far as possible, eliminated and acknowledged risks were reduced.
The structurally unavoidable hazard points are marked by labels and signs.
These must always be easy to read.
Special safety instructions
... indicates hazards due to electrical voltage.
Where safety notices are not observed there is a danger of serious or
deadly injuries.
Responsibilities of the operator, installation of safety systems (RCD)
that detect a short-circuit and isolate all connected phases.
... indicates hazards from hot surfaces.
Where safety notices are not observed there is a danger of burns and
serious skin injuries due to heat.
... indicates hazards due to catching.
Failure to observe the safety instructions may result in hand injuries.
… indicates a risk of cutting due to rotating cutting blade.
Failure to observe the safety instructions will result in the risk of cuts
and serious injury from a rotating cutting blade.
... indicates dangers due to trapping.
Where safety notices are not observed there is a danger of serious or
deadly injuries.
... indicates that it may not be operated by persons with a pace-maker.
Where safety notices are not observed there is a danger of impairment
to persons with a heart pace-maker.
... indicates a ban on carrying metal parts.
Carrying metal items, watches, magnetic or electronic data devices is
forbidden, as the magnetic field can damage or destroy the items.
