en
Operating the appliance
18
Measuring aid* for liquid detergent
Position the measuring aid for dosing
the correct amount of liquid detergent:
1.
Pull out the detergent drawer.Press
down the insert and fully remove the
drawer.
2.
Slide the measuring aid forwards,
fold it down and click it into place.
3.
Reinsert the drawer.
Note:
Do not use the measuring aid for
gel detergents and washing powder, or
for programs with prewash or when the
"Fertig in" (Ready in) time is selected.
Start the programme
Press the Start - Pause
í
button. The
indicator lamp lights up and the
program starts.
The display panel shows the Ready in
time while the program is running or the
program duration and the program
progress symbols once the wash cycle
has started.
Note:
Foam detection
If the
Å
symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next wash
cycle with the same load.
If you want to lock the program to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Childlock
(3sec.
E
)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock when the
program has started.
To
activate/deactivate
, press and hold
the
0
Spin
and
Delay
buttons at the
same time for approx. three
seconds.The
E
symbol appears in the
display panel.
■
E
lights up: The childproof lock is
active.
■
E
flashes: The childproof lock is
active and the program selector has
been adjusted.To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol lights up again.
Note:
To avoid the program to
terminate, do not turn the program
selector beyond the Off position.
Note:
The childproof lock remains
active after the program has ended and
the appliance is switched off. You must
always deactivate the childproof lock if
you want to start a new program.
Adding laundry
Following the start of the program, you
can add or remove laundry as required.
Press the Start - Pause
í
button to do
this.
The Start - Pause
í
button indicator
lamp flashes and the machine checks
whether it is possible to add laundry.
If the following appears in the display
panel:
■
the
ú
symbol disappears, and
adding is possible.
■
the
ú
symbol lights up, it is not
possible to add laundry.
