Schulthess 8230.1, Инструкция по использованию

Страница: 62 / 68

Cleaning and Maintenance
Cleaning the air cooler
The air cooler should be cleaned after every 10th drying
procedure.
1.
Press the button to release the maintenance flap.
2.
Turn the two closing levers in the indicated direction
against each other.
3.
Pull out the air cooler.
4.
Rinse the air cooler thoroughly under running water and
allow to drain
5.
Replace the air cooler. The handle must be at the
bottom. Turn the lock levers back again to lock.
6.
Push the upper left edge of the maintenance flap until
the lock engages.
Cleaning the moisture sensor
After longer operation, small deposits (lime, fabric refiner)
can form on the front inner side of the drum on both
sides of the longish moisture sensors.
With moisture controlled programmes, this can result
in the desired level of dryness not being reached.
Wipe deposits away with a cloth soaked in vinegar.
Cleaning the filter support
1.
From time to time it is necessary to remove fluffs that
have accumulated inside the filter support. To do so, use
a vacuum cleaner or a cleaning brush.
2.
Run the pipe of the vacuum cleaner or the brush around
the opening for the fluff filter. Remove any residual fluff.
3.
Replace the filter properly.
4.
Close the door.
Cleaning the machine
Ensure that the power supply is switched off before any
cleaning, care or maintenance work.
Under no circumstances spray the machine with water or
clean it with a steam cleaner.
Do not use solvents! These substances can damage parts
of the machine, produce poisonous vapour and carry the
risk of explosion!
Casings and control areas should only be cleaned with
soap or a commercially available, solvent-free, non-abra-
sive cleaning product.
62