Schulte SDX-102, Руководство оператора

Страница: 70 / 104

OPERATION
SDX-102 05/19 Operation Section 4-28
© 2019 Alamo Group Inc.
OPERA
T
ION
Before operating the snow blower recheck that all
fasteners, nuts, bolts, screws and cotter pins are in
place and all bolts are torqued to specification.
Only operate the snow blower in conditions were you have clear visibility in daylight or with
adequate artificial lighting. Never snow blow in darkness or in conditions where you cannot
clearly see at least 100 yards in front and to the sides of the Tractor and Snow Blower.
Make sure that you can clearly see and identify passersby, steep slopes, ditches, drop-offs,
overhead obstructions, power lines, debris and foreign objects. If you are unable to clearly
see these types of items, discontinue snow blowing.
(SSB-1)
When blowing snow with two machines in the same area be sure that windows are closed.
(SSB-10)
If removing snow from other than paved or hard surfaced areas, move deflector to the low
position to minimize the distance that gravel or foreign material is ejected.
Never direct discharge of snow towards people, pets, or property.
Excessive speed of drop may cause damage or injury. Fully lowering implement should
require at least two seconds.
Do not operate the snow blower PTO drive in the fully raised position.
Stop engine, disengage power take-off, and remove ignition key whenever leaving tractor
operating position.
DO NOT operate this Implement on a Tractor that is not properly maintained. Should a
mechanical or Tractor control failure occur while operating, immediately shut down the
Tractor and perform repairs before resuming operation. Serious injury and possible death
could occur from not maintaining this Implement and Tractor in good operating condition.
(SG-36)