SCHOTT VisiLED MC 1000, Руководство пользователя

Страница: 63 / 104

GB
61
MC 1500
If you are unable to rectify the fault
by the actions mentioned above,
please contact your specialist dealer
or the nearest SCHOTT agency. More
extensive repairs must be carried out
by the authorized customer service
depot.
Fault Possible causes and remedial action
15. Trigger mode:
Light pulse mistimed
• Optimize time delay between trigger pulse
and light pulse (also see Section 8.6).
• Were different delay times stored in the memory
stations of the MC 1500? Correct recall of all
delay times is not possible then. Please use in
trigger mode one memory station only or store
identical delay times in all used memory stations.
16. Trigger mode:
not all trigger
signals recognized
• Does trigger pulse occur too soon after light
pulse? Reduce duration of light pulse!
• Is trigger signal too short? Please increase time
of the trigger pulse (see also Section 8.6).
17. Flash mode:
Flashing via
synchronous flash
cable not functioning
• Is flash cable connected correctly? (14)
• Are both LED illuminations in the 0 to 3
brightness range?
Two green LEDs maximum (4) should be lit up.
If necessary turn down the brightness of both
units appropriately using (5) (see Section 8.6).
• Is flash pulse duration too short?
If necessary increase via PC control.
• Are strobe mode and trigger mode deactivated?
If necessary deactivate for both LED units
(see Section 8.6).
18. Flash mode:
Flash not bright
enough
• Is flash pulse duration too short? If necessary
increase via PC control.
• For maximum flash intensity increase the
brightness of both units until the third LED of
display (4) “just doesn’t” light up.