SCHOTT VisiLED MC 1000, Руководство пользователя

Страница: 61 / 104

GB
59
MC 1500
Fault Possible causes and remedial action
1. No light,
A/B LED display (1)
no lit up
• Is electronic power supply correctly connected
to LED controller and power cord? (16)
• Is correct supply voltage available?
• Is controller switched on? (17)
2. No light,
A/B LED display (1)
lit up
• VisiLED illumination(s) connected correctly?
(11), (12)
• VisiLED illumination(s) dimmed down to
brightness 0? Select each illumination unit
with unit selector key (1) and increase
brightness (5).
3. No light,
LED display A/B (1)
lit up
LED display (4) rolling
• LED illuminations in trigger mode.
Deactivate trigger mode by pressing key
combination (10) + (9) or increase intensity and if
necessary pulse duration of individual light
(see Section 8.6)
4. No light,
A/B LED display (1)
lit up, three LEDs of
display (4) lit up
• Is selected VisiLED unit in strobe mode?
Increase strobe intensity and possibly strobe
pulse duration
or deactivate strobe with (9)
(see Section 8.6)
5. No light,
redLED display (8)
permanently lit up
• LED illumination(s) heated up excessively.
Reduce brightness slightly (5) until the red LED
goes out, if necessary for both LED units.
6. Light available, red
LED display (8) blinking
• Warning that the LED illumination is
approaching the permitted temperature limit.
7. Not possible to set
brightness by pressing
key (5)
• Is the VisiLED unit to be set already selected?
If necessary activate switch (1).
• Deactivate strobe with (9) or increase strobe
intensity and if necessary strobe pulse duration
(see Section 8.6).
• Is selected VisiLED unit in trigger mode?
Deactivate mode using (10) + (9) or increase
intensity and if necessary pulse duration of
individual pulse (see Section 8.6).