Legacy Protocol
Controls
D20980.026 Rev B
CV-LS Programming Guide
Page 23
3.5
Equalizer
3.5.1
Equalizer Enable
&E#
Gets/Sets if the system equalizer is enabled.
Input Options (#): 0 = Disable, 1 = Enable, ? = Query
Return string:
&eX
Return value (
X
): 0 = Disable, 1 = Enable
3.5.2
Start-up Delay
&EI#
Gets/Sets the time delay from turning on the unit to passing control of the light output
to the equalizer control loop.
Input Options (#): 0 – 500 = Delay in Decimal Format, ? = Query
Return string:
&eiX
Return value (
X
): 0 – 500 in 3 digit Decimal Format “&eeXXX”
3.5.3
Target Light Output
&EE#
Gets/Sets the target value used in the equalizer control loop.
Input Options (#): 0 – 4095 = Target Value in Hex Format, ? = Query
Return string:
&eeX
Return value (
X
): 0 – 4095 in 3 digit Hex Format “&eeXXX”
3.5.4
Current Light Output
&EV?
Returns the current Light Feed Back value used in the equalizer control loop. This value
is averaged over time from the raw Light Feed Back (LFB) value of the system.
Return string:
&evX
Return value (
X
): 0 – 4095 in 3 digit Hex Format “&eeXXX”
Note:
Unit will accept command without (?) for backwards compatibility.
3.5.5
Equalizer Output
&ED?
Gets the current output power from the equalizer control loop in Hex format.
Return string:
&edX
Return value (
X
): 0 – 4095 in 3 digit Hex Format “&edXXX”
Note:
Unit will accept command without (?) for backwards compatibility.
