Scholl 26060/4, Инструкция по эксплуатации

Страница: 6 / 26

GBA C 0100 2 E
BA Page 6 of 26 Januar 16, 2018
Last revised 01-2018 Rev. 2
Scho
ll Ap
parat
eb
au
G
mb
H &
C
o
.
KG
1 C
ONVENTIONS
1.1 P
ICTOGRAMS
– G
ENERAL SAFETY NOTES
Be sure to observe these Instructions for Use as well as the safety notes to prevent
injuries or damage to health or property. Do not alter or modify this appliance.
Never use a defective appliance. If you suspect the unit of being faulty or discover
an unusual noise or smell, turn off the power switch and pull the plug out of the
socket-outlet, or otherwise disconnect the appliance from the mains and de-
energize it (i.e., ensure that it no longer carries any voltage). Do not use this appli-
ance when its power cord is damaged.
Failure to observe this warning may result in a fire hazard or electrical shock!
Maintenance and repair work must be carried out only by qualified professionals
using original spare parts and accessories. Do not attempt to carry out repairs on
this appliance yourself!
Connect this appliance to suitably earthed mains outlets only. Ensure that your
mains power supply conforms to the data stated on the nameplate of the appliance.
Failure to observe this warning may result in a fire hazard or electrical shock!
Place this appliance on a sturdy, level and heat-resistant surface to prevent fire
hazards and accidents.
This appliance is not intended to be used by persons (including children) of limited
physical, sensory or intellectual abilities, or lacking in experience and/or knowledge,
unless they are supervised by a person responsible for safety who instructs them in
the use of the device. Children should be supervised to ensure they will not play
with this appliance.
Do not run the power cord near heat sources, over sharp edges, etc. Always pull on
the plug, not the cord, to remove it from a socket-outlet since the cord might be
damaged as a result. Do not allow cords to hang unsupported. Route the cord so
that it will not form a tripping hazard!
Do not allow this appliance to operate unattended. Ensure that its thermostat
switch is set to „0“ before inserting the plug into an electrical socket-outlet or con-
necting the appliance to the power supply. Avoid starting the unit unintentionally.
Connecting the unit to the mains with its thermostat switch not set to „0“ may
cause accidents.