Schneider Airsystems D 040 025, Оригинальное руководство по эксплуатации, Страница: 22 / 56

II/6
FP
GB
Manual operation:
Each time the trigger lever (item 02) is
pulled, a shot of grease is dispensed.
Automatic operation:
Pulling the trigger lever (item 02) dispenses
grease automatically in shots until the trig-
ger lever is released or the grease chamber
is full.
After use:
1. Disconnect the quick-action coupling
from the plug nipple (item 01)
(Figure 1b).
2.5 Maintenance
L
Regular lubrication is required!
X
Oil using a maintenance unit
with filter pressure reducer and mist oiler.
X
Without mist oiler: oil daily by hand via the
plug nipple (item 01).
X
In the event of longer interruptions in op-
eration, also lubricate via the plug
nipple (item 01).
2.6 Decommissioning
Storage: Clean, dry, free from dust, above
5° C.
Disposal: Dispose of packaging / machine
according to valid statutory regulations.
2.7 Warranty
Basic principle: complete unit in original
condition / proof of purchase.
Material and production defects are covered
by statutory provisions.
Excluded warranty claims: Wear or ex-
pendable parts, improper use, overloading /
incorrect pressure, manipulation / inappro-
priate use, inadequate / incorrect / lack of
maintenance or lubrication, bumps / im-
pacts, dust / dirt accumulation, unauthorised
/ incorrect working procedures, incorrect
power supply, impure / insufficiently filtered
compressed air, failure to read the instruc-
tion manual, incorrect operating resources /
materials.
2.8 Troubleshooting
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
If necessary, contact our service staff, see last page.
Problem Cause Remedy
A No function is
apparent after
pulling the trigger
lever (item 02)
Trigger lever (item 02) / trig-
ger valve defective
X
Replace trigger lever (item 02) / trigger
valve
No connection to compressed
air
X
Connect to compressed air
***
B Grease gun dis-
penses too little
grease or none at
all
No grease in grease reservoir
(item 05).
X
Add grease
Grease gun not vented
X
Actuate the venting valves (item 03)
Grease gun not vented after
the cartridge is changed
X
Actuate the venting valves (item 03)
Cartridge inserted incorrectly
X
Reinsert cartridge
***
Grease piston is damaged
X
Replace the grease reservoir (item 05)
Sealing (item 10) in front
housing defective (fig. 2a)
X
Replace the sealing (item 10)
Grease too hard
X
Heat up grease slightly
Unsuitable material for the
device used
X
Use suitable material for the device
**
Hose diameter too small
X
Use correct hose diameter
*
Compressor output too small
X
Use suitable output capacity
*
Working pressure (flow pres-
sure) too low
X
Increase working pressure (flow pressure)
Observe maximum working pressure
*