schmersal SRB-E-212ST, Руководство по эксплуатации

Страница: 5 / 12

5
SRB-E-212ST / SRB-E-322ST
Operating instructions
Safety-monitoring module
EN
5. Operating principle and settings
5.1 Description of the terminals and LED indications
Pin Function LED Function
A1 Operating voltage
+ 24DVC RUN Operating voltage OK
RUN mode
For flash code, see
section 5.3
A2 Operating voltage
0 V
ERR Error code
refer to part 5.5
X2 Input of start circuit
X3
Input
feedback circuit
X7 Input
Release signal
S11/S21 Test pulse outputs
S12
Input channel 1
In 1
High level at S12
For flash code, see
section 5.4
S22 Input channel 2 In 2 High level at S22
For flash code, see
section 5.4
Y1 Signalling output
(NC) STOP 0
Y2 Signalling output
(NC) STOP 1
41/42 Signalling contact
(NC) STOP 0
13/14,
23/24,
33/34 Safety outputs
STOP 0 Out 1 Outputs activated
For flash code, see
section 5.4
Qt1/Qt2 Safety outputs
STOP 1 Out 2 Outputs activated
For flash code, see
section 5.4
1
0
S11 S12 S21 S22
A1 A2 X3 X2
X7 Qt1 Y2 Y1
S
R
B
-E
-2
12
ST
24 23 14 13
Out 2
time[s]
RUN
ERR
ln 1
ln 2
Out 1
mode
1
0
S11 S12 S21 S22
A1 A2 X3 X2
Qt2 Qt1 X7 Y2
S
R
B
-E
-3
22
ST
24 23 14 13
42 41 34 33
time[s]
RUN
ERR
ln 1
ln 2
Out 1
Out 2
mode
Adjustment of application using rotary “mode” switch
• Open front transparent cover (see fig.).
• Opening is carried out by lifting side with lock.
• Select desired application using rotary mode switch (1 … 10)
by turning up or down (see 5.3).
• Adjust drop-out delay (0 … 30 sec.) with rotary time switch
(16 increments) by turning up or down (see 5.3).
• After performing setting, close front cover again.
• Front cover can be secured with a lead seal to protect it from being
opened unintentionally
Only touch the components after electrical discharge!