Schmeiser TILL AN'PAK TPP3510, Руководство по эксплуатации и запасным частям, Страница: 30 / 44

T.G. Schmeiser Co., Inc. TP Hydraulic Transport Kit
Ph. (559) 268-8128
Fax (559) 268-3279
www.tgschmeiser.com
30
1. Lay Till An' Pak Frame on ground.
2. Unbolt Till An' Pak Frame from Pillow Block Bearings
on Roller. Do not remove Pillow Block Bearings from
Roller.
3. Position each End Bracket (1) between Till An' Pak
Frame and Pillow Block Bearing.
- Be sure that the angle iron leg of the End Bracket
points inward. Refer to the drawing for positioning.
- Use (4) 1/2" x 3" or (4) 5/8" x 3" Bolts to fasten
Pillow Block Bearing, End Bracket, and Till An' Pak
Frame.
- Use (4) 5/8" x 6" Bolts to attach End Bracket - Roller
Frame Mount Plate.
All fasteners - hand tighten only!
4. Remove Tongue Pin from Till An' Pak Frame. It is
located at the base of the Frame tongue guide.
5. Position Center Bracket (2) on the tongue guide of the
Till An' Pak frame. The two ears at the bottom of the
center bracket should slide over the tongue guide pin
hole of the Till An' Pak frame. The cylinder anchor
portion of the Center Bracket should be facing upward
at a 45-degree angle aimed toward the rear of the
unit. Refer to the drawing for the positioning.
- Place 1-1/2" x 6-1/2" Tongue Pin in the tongue guide
hole. Remember, the tongue, the Center Bracket and
the tongue guide hole on the frame all have to line up
in order to properly install the tongue pin.
- Use (4) 5/8" x 6" Bolts to attach Center Bracket -
Roller Frame Mount Plate.
All fasteners - hand tighten only!
6. Position Main Cross Bar on top of the End Bracket.
The bar should be placed between the two holes on
the topside of the End Bracket. The truss strap should
be positioned on the top and the two sets of the
Bearing Mount Plates welded on the Main Cross Bar
should be placed to the back side of the machine.
TPP3530 Transport Kit Assembly Instructions
WARNING
Understand Safety Procedures!
Read and understand all safety procedures
described in this manual before performing any work
on or around the implement.
- Use (4) 3/4" x 5" Bolts to attach Center Bracket -
Main Cross Bar Mount Plate.
- Use (4) 3/4" x 7-1/2" Bolts to attach Main Cross Bar
- End Bracket Mount Plate.
All fasteners - hand tighten only!
7. Attach Wheel Axle (15) to Main Cross Bar using the
Bearing Assemblies. The Cylinder anchor on the
Wheel Axle should be facing in the upward position.
8. Attach 3-1/2" x 10" Hydraulic Cylinder (4) to Center
Bracket and Wheel Axle. The rod clevis of the
cylinder should attach to the wheel axle cylinder
anchor.
9. Securely tighten all fasteners.