Schmeiser TILL AN'PAK TPP3510, Руководство по эксплуатации и запасным частям, Страница: 22 / 44

T.G. Schmeiser Co., Inc. TP Hydraulic Transport Kit
Ph. (559) 268-8128
Fax (559) 268-3279
www.tgschmeiser.com
22
TPP3510 Transport Kit Assembly Instructions
1. Lay Till An' Pak Frame on ground.
2. Unbolt Till An' Pak Frame from Pillow Block
Bearings on Roller. Leave Roller attached to Pillow
Block Bearings.
3. Position each End Mount (1) between Till An' Pak
Frame and Pillow Block Bearing (9). - Refer to the
drawing for positioning.
4. Place Wheel Axle (7) with Plastic Bushings (2)
between End Mounts (1).The Cylinder anchor on the
Wheel Axle should be facing in the upward position.
5. Bring in End Mounts (1) and install and tighten all
fasteners.
- Use (4) 1/2" x 3" Bolts to fasten Pillow Block
Bearing, End Mount, and Till An' Pak Frame.
- Use (8) 5/8" x 6" Bolts to attach End Mount to
Bottom Clamp Plate (11).
6. Remove Tongue Pin from Till An' Pak Frame. It is
located at the base of the Frame tongue guide.
7. Position Center Frame (3) on the tongue guide of
the Till An' Pak frame. The two ears at the bottom of
the center bracket should slide over the tongue
guide pin hole of the Till An' Pak frame. The cylinder
anchor portion of the Center Frame should be facing
upward at a 45-degree angle aimed toward the rear
of the unit. Refer to the drawing for the positioning.
8. Place 1-1/2" x 6-1/2" Tongue Pin in the tongue guide
hole. Remember, the tongue, the Center Frame and
the tongue guide hole on the frame all have to line
up in order to properly install the tongue pin.
- Use (2) 5/8" x 5-1/2" Bolts to attach Center Frame
to Front Clamp Plate.
9. Attach 4" x 12" Tie Rod Hydraulic Cylinder (4) to
Center Frame and Wheel Axle. The rod clevis of
the cylinder should attach to the wheel axle cylinder
anchor.
WARNING
Understand Safety Procedures!
Read and understand all safety procedures
described in this manual before performing any work
on or around the implement.
10. Install Cylinder Lockout Bar (4). See drawing for
proper installation.
11. Install wheels / tires on the wheel axle.