Schmalz SMPi 20, Руководство по эксплуатации, Страница: 34 / 50

S
CHMALZ
SCP
I
/ SMP
I
4-34
Resetting to the factory settings (Clear All) [rES]
This function is used to reset the ejector to its factory settings.
All switching points and configurations are reset to the factory settings. The
counters are not affected by this function.

Press the button for more than 3 seconds.

Enter a valid PIN if the menu is locked.

Select the
[rES]
menu item using the or buttons.

Press the button for more than 3 seconds to reset to the factory settings.
After confirmation is made, the display flashes briefly and then returns automatically to dis-
play mode.
The factory settings of the ejector can be found in the appendix.

The zero-point adjustment is also reset. The zero point may need to be set again
[CAL]
.
The switching points and configuration of the signal output are changed by re-
setting to the factory settings. The signal on the signal output may change as a
result.