Schmalz 10.02.02.05827, Руководство по эксплуатации

Страница: 28 / 72

General Description of Functions
28 / 72 EN-US · 30.30.01.02084 · 02 · 12/20
When the permissible limit is exceeded by ±3%, error code
E03
will appear on the display.
7.10 Signal Output
The ejector has a signal output. The signal output can be configured using the corresponding menu item.
The signal output OUT can be switched between [
no
] (normally open) and [
nc
] (normally closed) con-
tact. You can switch it in the configuration menu using the [
0-2
] menu item or set it via IO-Link. The
function of the limit value H2/h2 (“Part Present” check) is assigned to the signal output OUT.
The signal output is switched on or off when the system vacuum is higher or lower than the relevant
threshold value.
The output type parameter can be used to switch between PNP and NPN. The signal inputs are also con-
figured with this function. This setting can be switched using the [
tYP
] menu item in the configuration
menu or via IO-Link.
7.11 Signal Type
The signal type, or the switching behavior (PNP or NPN) of the electrical signal inputs and the signal out-
put, can be set on the device and therefore does not depend on the version. You can switch this setting
using the [
tYP
] menu item in the configuration menu or via IO-Link. The ejector is factory set to PNP.
7.12 Control Concept for NO Ejectors
1
1
0
0
“Suction” [IN1]
“Blow off” [IN2]
“Blow off” state
“Suction” state
-p
p
0 bar
0 bar