Schluter Systems LIPROTEC LT ES 1, Инструкция по применению

Страница: 33 / 219

EN
Connection
30 Directions for use for LED strips
6 Connection
DANGER
Risk of fire due to the overheating of the cable!
Fires resulting from overheated cables can lead to deadly burn injuries or poisoning by
smoke inhalation.

Do not lay the cable when it is unwound.

Use a sufficient cable cross-section.

Take the maximum permissible length of the supply lines into consideration.

Observe the maximum permissible capacity of the power packs and receivers.
ATTENTION!
Malfunction due to damaged cable.
Conducting the cables along sharp edges can lead to malfunctions.

Lay the cables in empty tubes or cable channels.

Deburr the boreholes and notches in LIPROTEC profiles.
ATTENTION!
Malfunction due to the loosening of the cable connection.
Connecting tensioned cables can lead to a loosening of the cable connection.

Guarantee sufficient tension relief.
6.1 Optimizing radio noise suppression
To obtain good radio noise suppression and the greatest possible operating safety, observe
the following points for expert line laying:

Mount the power packs at least 30 cm from the LED-conducting aluminium profiles. In
the process, observe the minimum distances to the neighbouring components (see the
"Directions for use for the power pack," Fig. C).

Properly lay the output lines at a corresponding distance to the earthed metal surfaces.

This reduces capacitive interference.

Make sure the distance between the mains cable and connection cable of the receiver
or LED strip is as large as possible (at least 5 cm) and mains and connection cables are
not laid in parallel.

As a result, interference between the mains cable and lamp connection cables is
prevented.

Avoid intersecting the mains cable and LED modules. If you cannot prevent an
intersection, design it with the largest possible angle as far as possible for technical and
safety reasons.

This prevent HF interference with the mains cable.