Schleuniger CoaxCenter 6000, Справочное руководство, Страница: 112 / 194

11. Diagnostics / troubleshooting
112 | 194
Reference Manual |Edition 5.0 (09-2016) | CoaxCenter 6000
Diagnostics Cause of fault Actions to be taken
Feeding mechanism not
working
Cable length not correct
■
Tension force on wire straight-
ener too high
■
Cable feeding improperly
■
Feeding speed too high
■
Fault on prefeeder
■
Reduce tension force to the
wire straightener
■
Check for constant and
smooth wire guiding
■
Reduce speed and accelera-
tion in the configuration of
the control software
■
Inspect the functioning of the
prefeeder.
No feeding of article even if
feeding belts are moving
■
Contact pressure too low
■
Outworn or slippery feeding
belts
■
Tension force on wire straight-
ener too high
■
Increase contact pressure
■
Replace feeding belts
■
Reduce tension force to the
wire straightener
Bad incising quality
■
Outworn blades
■
Elastically insulation
■
Wrong blade type
■
Replacing blades
■
Increase the pause in the pro-
cessing
■
Use suitable blades
Insulation is not stripped
properly
■
Pull-off speed too high
■
Contact pressure too low
■
Incisise diameter wrong set-
tings
■
Wrong blade type
■
Outworn blades
■
Pull-off length too short
■
Adjust pull-off speed
■
Increase contact pressure
■
Exchanging feed belts
■
Correct incising diameter val-
ue
■
Mount other blade type
■
Replacing blades
■
Change pull-off length
Cable is flat or damaged
■
Contact pressure too high
■
Correct contact pressure
Tab. 5: Causes of faults and action required
11.3
STATUS MESSAGES ON THE DISPLAY
On the touch screen, status messages are displayed which may show up before, during and after the
production. This can be a production- or an error message.