MVPHD-24 Operations Manual Version 0.9.0 page 27 of 74
October 26, 2020
OUTPUTS:
This button is used to access menus for output configuration.
Menu:
Output Frame Rate:
This menu is used to select the base frame rate of all the outputs of the MVPHD-24.
The base frame rates 23.976, 24.000, 25.000, 29.970, and 30.000 are supported. Multiples
of these frame rates are possible, depending on the selected format.
This selection has no effect on the color standard of the composite output (see
Composite
Standard
to select color standard). Any color standard can be produced at any frame
rate; for example NTSC is not limited to 29.970 but can also be 25.000, 24.000 etc.;
PAL is not limited to 25.000 but can also be 29.970, 24.000 etc.
Use the Knob (rotate) or +/- buttons to select the desired frame rate.
Once the frame rate is selected, push on the knob to enter selection.
Menu:
Output Format:
This menu is used to select the video format for all outputs (except the composite reference
output). The video format options depend on the frame rate, and the output mode. For
example, VGA resolutions are only available when VGA is the selected output mode.
Use the Knob (rotate) or +/- buttons to select the desired format.
Once the format is selected, push on the knob to enter selection.
Menu:
Primary Output Mode:
The MVPHD-24 is not capable of producing perfect images on all outputs simultaneously.
Therefore the primary output mode is used to select the output that is most important.
The other outputs may continue to work but the quality may be degraded. This setting
affects what video formats are available. For example, VGA resolutions are only available
when VGA is the selected output mode. The selected primary output is always shown
on the top line status of the front panel display.
Use the Knob (rotate) or +/- buttons to select the primary output.
Once the primary output is selected, push on the knob to enter selection.
Menu:
Composite Standard:
This menu is used to select the composite outputs’ color standard. The MVPHD-24 supports
NTSC, PAL-M, PAL, and PAL-N. This selection has no effect on the frame rate of the output
(see
Output Frame Rate
to select frame rate). Any color standard can be produced at any frame
rate; for example NTSC is not limited to 29.970 but can also be 25.000, 24.000 etc.; PAL is not
limited to 25.000 but can also be 29.970, 24.000 etc.
Use the Knob (rotate) or +/- buttons to select the desired color standard.
Once the color standard is selected, push on the knob to enter selection.
Menu:
Output YPbPr Level:
This menu is used to configure the signal levels when YPbPr is the selected output. (see
Primary Output Mode
to select YPbPr). Options are: EIA770/EBU, or Betacam.
Note: EIA770/EBU is 100% color = 700mV, Betacam is 75% color = 700mV
Use the Knob or +/- buttons to change the signal level.
