Schimpf 00-10/30 STEP, Руководство по эксплуатации

Страница: 38 / 74

Operation
©
by Antriebs- & Regeltechnik Schimpf GmbH 38
Standard mode
To put the actuator in standard mode, set the
“Mode”
rotary switch to
“0”
. In this
mode, you can then use the
“Parameter”
rotary switch to select the operating mode.
Parameter 0: Operating mode idle or deactivated
The drive is in idle mode. The drive will not move regardless of the applied input
signals. The “Ready for operation” relay is not switched.
Parameter 1: Manual movement mode
The drive can only be moved using the and buttons. When the minimum or
maximum end position is reached, the rotary movement stops.
The “Ready for operation” relay is
not switched.
Parameter 2: Control with setpoint enabling
When voltage is applied to terminal 12 (enable signal), the drive is in control mode .
The drive will move to the position according to the analogue input signal at terminal 3.
If no voltage is applied to terminal 12 (enable signal), the drive is in three-point step
mode : If a voltage is applied to terminal 11, this causes the drive to rotate clockwise
(CW) . If the voltage is interrupted at terminal 11 or the end position is reached, the
rotary movement stops. If a voltage is applied to terminal 13, this causes the drive to
rotate counterclockwise (CCW) . If the voltage is interrupted at terminal 13 or the
end position is reached, the rotary movement stops.
The “Ready for operation” relay is switched.
Parameter 3: Three-point step with enabling
If voltage is applied to terminal 12 (enable signal), the drive is in three-point step
mode : If a voltage is applied to terminal 11, this causes the drive to rotate clockwise
(CW) . If the voltage is interrupted at terminal 11 or the end position is reached, the
rotary movement stops. If a voltage is applied to terminal 13, this causes the drive to