Schimpf 00-10/30 STEP, Руководство по эксплуатации, Страница: 14 / 74

Commissioning
©
by Antriebs- & Regeltechnik Schimpf GmbH 14
Opening the housing cover
To open the housing cover, loosen the four 3 mm hexagon socket screws in the
corners.
Important: When working on the open device, always observe the safety
requirements.
Important: Before opening the housing cover, disconnect all cables
connected to the drive from mains power!
Important: As soon as the configuration of the device is complete or paused,
the housing cover must be replaced immediately.
Electrical connection
The connection cables must be fed through the cable glands (00-10: 3x M16x1.5,
Ø: 5-9 mm), (00-15,01-15: 2x M20x1.5, Ø: 9-13 mm) into the housing.
The cable glands must then be tightened firmly. The permissible outside diameter of
the inserted cables must be observed.
The connections must be made in accordance with the instructions in the section
Connections .
Important: The protective conductor (terminal 6) must always be connected.
Setting the end positions
The end positions for “Closed” and “Open” are set at the factory to a setting range of
approx. 90°. The position is determined using the potentiometer integrated into the
device. The positions of the two end positions are stored in the device memory. If
necessary, the end positions can be adjusted. The maximum setting angle is approx.
110°.
Instructions for setting the end positions are provided in the section Configuration
mode 1 under menu item Mode 9: Setting the end positions .