Schiller BR-102 PLUS, Руководство пользователя, Страница: 45 / 76

Page 45
A
rt.
no.
: 2.
511
076 Rev.:
g
Cleaning 5
User Guide Important Information 5.1
BR-102 plus / BR-102 plus PWA
5.1.2 Admissible detergents
• 50% solution isopropyl alcohol
• neutral, mild detergent
• all products designed for cleaning plastic.
5.1.3 Cleaning the Device
Before cleaning the unit or any accessories, thoroughly inspect them.
Look for any signs of damage and any improper mechanical function
of buttons or connectors.
The casing of the BR-102 plus / BR-102 plus PWA and the cable
assemblies can be cleaned with a cloth slightly moistened (not wet) on
the surface only. Where necessary a domestic non-caustic cleaner or
70% alcohol solution can be used for grease and finger marks. Wipe
the equipment with a cloth
slightly moistened ( not wet ) with one of
the approved solutions listed above. Wipe off any excess cleaning
solution. Do not let the cleaning solution run into or accumulate in
connector openings, latches, or crevices. If liquid gets into connectors,
dry the area with warm air, and then check the equipment to confirm
that it operates properly.
5.1.4 Cleaning the Pressure Hose/Microphone Cable As-
sembly
1. Before cleaning, inspect the hose/cable for damage. Gently bend
and flex all parts of the assembly. Inspect for splits in the sheath-
ing, damage or extreme wear, exposed wires, or bent connectors.
2. Wipe the equipment with a cloth slightly moistened ( not wet )
with one of the approved solutions listed above. Gently grip the
cable with the damp cloth in the centre of the cable and slide the
cable through the cloth 20 cm at a time until clean.
– Do not clean the whole length in one single action as this may
cause bunching of the sheathing.
– Wipe off any excess cleaning solution. Do not let the cleaning
solution run into or accumulate in connector openings, latches, or
crevices. If liquid gets into connectors, dry the area with warm air