Scheppach MS139-42, Перевод с оригинального руководства пользователя

Страница: 31 / 60

Seite 31 von 60 Seite 31 von 60
• Wedge a few layers of corrugated cardboard
between the upper and lower push bars and the
engine in order to prevent any chafing.
11. Disposal and recycling
Transport package disposal
The package protects the appliance against damage
during transport. Packing materials are usually cho -
sen depending on their environmental friendliness
and disposal method and can therefore be recycled.
Returning the package to material circulation saves
raw materials and reduces waste disposal costs.
Parts of packages (e.g. foils, styropor®) can be dan -
gerous to children. Risk of suffocation! Keep parts of
packages away from children and dispose them as
soon as possible.
The unit and its accessories are made of various ty-
pes of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
the cylinder with approx. 20 ml of oil from an oil
can. Slowly pull back the starter handle, which will
bathe the cylinder wall with oil. Screw the spark
plug back in.
• Clean the cooling fins of the cylinder and the
housing.
• Be sure to clean the entire machine to protect the
paint.
• Store the machine in a well-ventilated place.
Preparing the mower for transportation (Fig. 22)
• Empty the petrol tank.
• Always let the engine run until it has used up the
remainder of petrol in the tank.
• Empty the engine oil from the warm engine.
• Remove the spark plug boot from the spark plug.
• Clean the cooling fins of the cylinder and the
housing.
• Remove the start tension cable (17) from the hook.
Loosen the quick-release lever (5) and fold the
upper push bar down. Make sure the cables are
not bent during this process.
12. Troubleshooting
Troubleshooting
The table shows potential failures, their possible cause and removal options. However, if you are unable to remove
the problem, contact a professional to assist you.
m
CAUTION!
Always switch off the engine and pull the ignition cable before starting any inspection or adjustment work.
m
CAUTION!
If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that the exhaust and
other parts will get hot. Thus, do not touch parts that emanate heat, as these may burn you.
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Fault Possible cause Remedy
Loud while running,
machine vibrates
heavily
- Screws are loose
- Blade fasteners are loose
- Blade is unbalanced
- Check screws
- Check blade fasteners
- Replace blade
Engine does not start
- Brake lever not pressed
- Spark plug is defective
- Fuel tank is empty
- Contaminated fuel
- Cold environment
- Engine faulty
- Press brake lever
- Replace spark plug
- Refill with fuel
- Empty fuel tank and fill with clean fuel
- Push the primer button
- Contact authorised customer service
Engine runs unsteadily
- Air filter is soiled
- Spark plug is soiled
- Clean the air filter
- Clean the spark plug
Uneven mowing results
- Blade is blunt
- Cutting height is too low
- Sharpen the blade
- Set correct height
Unsatisfactory bagging
of the grass
- Cutting height is too low
- Blade is worn
- Basket is clogged
- Set correct height
- Replace the blade
- Empty the basket