www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
GB | 83
12. Troubleshooting
Fault
Possible cause
Remedy
The compressor does
not start.
• No supply voltage.
•
Insufficient supply voltage.
• Outside temperature is too low.
• Motor is overheated.
• Check the supply voltage, the power plug and the
socket-outlet.
• Make sure that the extension cable is not too long.
Use an extension cable with large enough wires.
• Never operate with an outside temperature of below
+5° C.
• Allow the motor to cool down. If necessary, remedy
the cause of the overheating.
The compressor starts
but there is no pres-
sure.
• The non-return valve leaks.
• The seals are damaged.
• The drain plug for condensation
water (1) leaks.
• Have a service center replace the non-return valve.
• Check the seals and have any damaged seals
replaced by a service center.
• Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools
do not start.
• The hose connections have a leak.
• A quick-lock coupling has a leak.
•
Insufficient pressure set on the
pressure regulator (7).
• Check the compressed air hose and tools and
replace if necessary.
• Check the quick-lock coupling and replace if neces-
sary.
• Increase the set pressure with the pressure regula-
tor.
