5
– FUNCTIONING AND USE
COD.
60M12/24.D.2018
EN
THE PRESENT MANUAL BELONGS TO -
Schenker Italia
- ALL RIGHTS RESERVED
39
NOTE
It could occur
that the system doesn’t stop immediately when stop button is pushed, but it rather
stops after a while. This behaviour is absolutely normal because the electronic central unit waits for
the hydraulic clock signal before switching off in order to avoid hydraulic system block.
CAUTION
If during normal running operation the computer detects an irregular condition (not constant
cycling, low pressure, etc…) the system switches off automatically after 20 sec, and STOP led
will start flashing. To make watermaker run again, it is first necessary to press STOP button (in order
give a feedback to the system that the issue has been recognized). Before pressing START to run the
watermaker again, be sure to individuate the cause of the anomaly and solve the issue.
5.4.3
Single washing operation
To perform a single washing operation, which flushes the system with fresh water for around 10 minutes in
order to avoid membranes to remain full of salt for long time, it is necessary to:
-
Select the pump mode P1+P2
-
Push the WASHING button for more than 3 seconds.
The display will indicate the remaining time. It is possible anyway to stop the operation at anytime by pushing
STOP.
5.4.4
Periodic washing
In order to program a periodic washing, which let the system rinsing automatically with a desired frequency,
please follow the instruction below:
-
Select the days (between 6 and 10) in the
“periodic washing” option within the menu
-
Exit from the menu by pushing STOP button
-
Push the WASHING button for 3 seconds
NOTE
In case the power supply is removed, it is necessary to set again the parameter.
