Schäfter+Kirchhoff SK12240U3KOC-LB, Инструкция по эксплуатации, Страница: 5 / 34

Sensor category CCD Color Sensor
Sensor type KLI-4104
Pixel number 4080 x 3
Pixel size (width x height) 10 x 10 µm
2
Pixel spacing 10 µm
Line spacing, line sequence 90 µm, green (G) - red (R) - blue (B)
Active sensor length 40.8 mm
Anti-blooming x
Integration control x
Shading correction x
Line synchronization modes Line Sync, Line Start, Exposure Start, Exposure Active
Frame synchronization x
Pixel frequency 60 / 30 MHz
Maximum line frequency 4.80 kHz
Integration time 0.01 ... 20 ms
Dynamic range 1:2500 (rms)
Spectral range 400 ... 700 nm
Video signal color 8/12 Bit digital
Interface USB 3.0
Voltage 5V DC (1.1A)
Power consumption 5.5 W
Casing Ø65 mm x 53.7 mm (Case type AT3L)
Objective mount M45x0.75
Flange focal length 19.5 mm
Weight 0.2 kg
Permissible casing temperature +5 ... +45°C
Introduction
5
Instruction Manual
SK12240U3KOC-LB
shar
ed_SystemRequir
ements_Specs_ML.indd
Instruction Manual SK12240U3KOC-LB © 2020-03 E
1.3 Computer System Requirements
1.4 SK12240U3KOC-LB Line Scan Camera - Specifications
Intr
oduction
The camera must be mounted thermally coupled
so that the acceptable casing temperature is not
exceeded during operation. Therefore applies to the
thermal resistance of the bracket or heat sink:
θ
amb
-
θ
casing
R
thHS
≤
P
camera
where
R
thHS
[K/W]
= thermal resistance of the bracket or heat
sink
θ
amb
[°C]
= ambient temperature
θ
casing
[°C]
= temperature of the camera casing (not
to be confused with the internal camera
temperature that is queried and output
with the request command I32)
P
camera
[W]
= camera power consumption
1) This camera is USB 2.0 downward compatible with the following limitation:
When connected to a USB 2.0 interface, the pixel data transfer rate is limited to 20 MByte/s and the line frequency is
limited accordingly.
2) The maximum power supplied by an USB 3.0 interface is 4.5 Watt. This is sufficient up to a pixel frequency of 60 MHz.
When operated at 100 MHz pixel frequency or when connected to an USB 2.0 interface an external 5 V DC power supply
unit is required (see section Accessories ).
2)
2)
1)
• Intel Pentium Dual Core or AMD equivalent
• RAM min. 4 GB, depending on the size of acquired
images
• USB 3.0 interface. With a USB 2.0 interface, there
are limitations, see footer.
• High-performance video card, PCIe bus
• Operating Systems:
Windows 7 / 8.1 / 10 (64 or 32-bit) or
Linux kernel 3.13 or higher