Assembly and commissioning
draft2go
BA-49-001-09
10 von 21
5.3
Assembling the dispensing head
5.3.1 Tappet and one-way line
Rinse out the tappet and the beer line under cold running water before
every use. This is easiest when the two components are assembled.
5.3.2 Attaching the dispensing head to the draft2go KEG
ATTENTION
Always attach the dispensing head so that the flat
fitting and the NC valve can be coupled to it.
Put the two sides of the insulator
jacket together, so that the hand-
holds on the jacket are in line with
those on the KEG.
Press the dispensing head onto the flat fitting
and the NC valve and pull it forward until the
dispensing head clicks into place. A clicking
sound can be heard.
