Operating and maintenance instructions
Installing optional attachments
Version 1.0
Page 34 of 56
6.3 Electromagnetic brake
Danger of property damage
Keep the brake surface free of oil and grease
6.3.1 Brake manufacturer: Intorq/Warner ERD 10/20/KEB
Example
Proceed in the order given:
Step
Procedure
1
Insert the feather key into the groove provided for this purpose.
2
Press the hub onto the shaft with a little force.
3
Secure the hub against axial displacement with the circlip.
4
Push the rotor onto the hub.
5
Check that the rotor can be moved by hand.
6
Push the magnetic part onto the hub.
7
Screw the magnetic part completely onto the bearing plate.
For this purpose, use the supplied screw set and a torque wrench (for
tightening torques see page 17).
8
Check the air gap SL (see table below) near the screws with a feeler
gauge.
9
Reset the dimension if the measured value "SL" is outside the tolerance.
To do this, loosen the cap screws a little and adjust the air gap with a
wrench over the sleeve screws.
10
Tighten the screws with a torque wrench.
NOTICE
