Scarab Magnum, Инструкция по эксплуатации и техническому обслуживанию

Страница: 12 / 48

Part No. SCAZ037886 8.6.00 12 E&OE
Merlin and Magnum Hydrostatic Operating Instructions
Auxiliary control panel switch functions
Forward/Reverse Lever - Lift collar to release from Neutral and move the lever in the desired direction to activate
the hydrostatic transmission. All active equipment will stop and retract to its stowage position when reverse is
selected, redeploying when reverse is disengaged.
High Pressure Water Pump (Option) - Press to start.
Suction Fan - Press to start the Suction Fan (approximately 2000 rpm on standard models and 2900 rpm on
high speed models).
Cruise Control - With the accelerator pedal depressed to the desired speed, press to activate cruise control.
Nozzle Tilt (Locking Mode) - Press to tilt the suction nozzle for larger items.
Suction Fan ‘Boost’ - With the Suction Fan ON, press to activate the fan boost mode. This increases fan speed
to approximately 2200 rpm on standard models.
On high speed models fan speed is 3150 rpm. To increase speed to 3400rpm press and hold until a red outer
appears on the fan symbol graphic. See Page 14.
Favourite Setting - Press to memorise your preferred sweeping set-up. Hold the switch down until a ‘beep’
sounds. Thereafter, whenever the switch is pressed at system start-up, the memorised configuration will be
automatically pre-selected/restarted. Repeat to over-ride with a new configuration.
Multi-Function Lever - ON (deploys all selected sweeping equipment). To stop and raise all sweeping equipment,
return the lever to the OFF position.
In the ON position the lever can be used to control the side brushe(s) and suction nozzle(s). These additional
positions i.e. Left, Right and Back, return to the central position when released.
The brush and nozzle functions are controlled as follows:
On Left Hand Drive Vehicles
Move the lever to the left to swing OUT, and to the right to swing IN the side brush(es).
On machines fitted with variable extend and retraction, move the lever momentarily in the desired direction to ‘nudge’ the brush(es).
On Right Hand Drive Vehicles
Move the lever to the right to swing OUT, and to the left to swing IN the side brush(es).
On machines fitted with variable extend and retraction, move the lever momentarily in the desired direction to ‘nudge’ the brush(es).
Nozzle Tilt Function
Move the lever back to momentarily tilt the suction nozzle or close it from TILT OPEN position.
On machines with variable nozzle-tilt, move the lever back to ‘nudge’ the suction nozzle DOWN from the TILT OPEN position.
Forward
Neutral
Reverse
Multi-function lever
OFF
ON
Nozzle tilt
Side
brush
Side
brush