Scantool COMPACT 75, Инструкции по безопасности и руководство оператора

Страница: 16 / 37

COMPACT 75
COMPACT 75
Operator’s manual for drilling machine - 16 -
Electromagnetic base clamping force control system
This system for security reasons is an integral part of each drill type PRO. It works by constant
monitoring of the electromagnetic force base adhesion value to the substrate. In the case of fall the
force value below to guarantee safe operation of the machine, the system automatically switches off
the drive drill. It also does not allow enabling drive which does not guarantee the proper clamping
force.
Clamping force depends on: type and thickness of substrate, thick coatings on the substrate, rust
or other contaminants, lack of flatness of the substrate, excessive roughness of the surface, and
excessive wear of the lower part of the electromagnetic base.
If there is a problem to enable drive after turn on of the electromagnetic base so drive works only
after START button is pressed, and after release the drive is off – it means that system works
properly. The system didn’t allow to for further work due to insufficient clamping force drills.
Working in difficult areas
While working in difficult access areas as well as left-handed operator, there’s a possibility to
change location of the pinion with spoke handles to the other side of drilling machine.
Additional option of machine COMPACT 75
Drilling machine COMPACT 75 is equipped with additional special function which enable to move
upper part of machine about 15 degrees and 15 mm front/back using allen key s=10, without moving
the electromagnetic base.
Drawing No 6.
Parameter of set-up magnetic base