Scanivalve MPS4232, Руководство по аппаратному и программному обеспечению

Страница: 69 / 96

63
MPS4232
Section 5: Software
Set Minimum Calibration and Validation Values (MIN)
COMMAND MIN
TYPE Set/Get
DESCRIPTION Sets the minimum calibration and validation temperature and pressure.
SYNTAX
SET MIN
<tcal> <pcal> <tval> <pval>
Where:
<tcal> = Minimum temperature value for a calibration.
<pcal> = Minimum pressure value for a calibration.
<tval> = Minimum temperature value for a validation.
<pval> = Minimum pressure value for a validation.
RETURNS Prompt when ready to accept a new command
EXAMPLE SET MIN 0 -5.5 10 -5.0
>
DEFAULT 0 -15 0 -15
RANGE These values are not range checked.
Set Maximum Calibration and Validation Values (MAX)
COMMAND MAX
TYPE Set/Get
DESCRIPTION Sets the maximum calibration and validation temperature and pressure.
SYNTAX SET MAX <tcal> <pcal> <tval> <pval>
Where:
<tcal> = Maximum temperature value for a calibration.
<pcal> = Maximum pressure value for a calibration.
<tval> = Maximum temperature value for a validation.
<pval> = Maximum pressure value for a validation.
RETURNS Prompt when ready to accept a new command
EXAMPLE
SET MAX 70 5.5 60 5.0
>
DEFAULT 70 15 70 15
RANGE These values are not range checked.
Set Oven and Calibrator Delays (DELAY)
COMMAND DELAY
TYPE Set/Get
DESCRIPTION Sets the delay in minutes and seconds for the oven and calibrator, respectively.
SYNTAX
SET DELAY
<iodelay> <odelay> <cdelay> <spcdelay>
Where:
<iodelay> = Initial oven delay in minutes.
<odelay> = Oven delay in minutes. Setting this value to zero enables a stable query to the MPS
(MPS must be +/-0.125°C for 10 minutes, 120 minute timeout).
<cdelay> = Calibrator delay in seconds. Setting this value to zero uses the calibrator’s STABLE
command.
<spcdelay> = Special Delay in seconds. This dwell is between the time between the positive
applied points, and the negative applied points.