Scanivalve MPS4232, Руководство по аппаратному и программному обеспечению

Страница: 68 / 96

62
MPS4232
Section 5: Software
Calibration Variables (LIST C)
The calibration settings control the calibration and validation of the MPS4200. See Section 6: Calibration and Validation Over -
view for more information on performing calibrations or validations.
List Calibration Settings (LIST C)
DESCRIPTION Returns all of the calibration settings
SYNTAX LIST C
RETURNS All of the calibration settings followed by the prompt.
EXAMPLE
LIST C
SET NUMPTS 0 9 0 9
SET MIN 40.000000 -5.500000 5.000000 -5.000000
SET MAX 60.000000 5.500000 55.000000 5.000000
SET DELAY 5 5
SET IPOVEN 0.0.0.0 0
SET IPCAL 0.0.0.0 0 1
SET CALAVG 16 16
SET VALZO 0
SET FCAL 3 -5.00 5.00
SET FVAL 3 -5.00 5.00
>
Set Number of Points in Conversion Table (NUMPTS)
COMMAND NUMPTS
TYPE Set/Get
DESCRIPTION Sets the number calibration and validation temperature and pressure points. This setting works
with the MIN and MAX setting to the calibration and validation points.
SYNTAX SET NUMPTS <tcal> <pcal> <tval> <pval>
Where:
<tcal> = Number of temperature points for a calibration.
<pcal> = Number of pressure points for a calibration.
<tval> = Number of temperature points for a validation.
<pval> = Number of pressure points for a validation.
These values are not range checked.
RETURNS Prompt when ready to accept a new command
EXAMPLE
SET NUMPTS 15 25 3 15
>
DEFAULT 5 9 5 9
RANGE <0 to 15> <0 to 25> <0 to 15> <0 to 25>