3
3
SC 8220 – 5004174-000 Rev. 01
Installation
WARNING
Risk of electric shock
The machine is of metal construction and must
therefore always be earthed to the supply. Ensure that
both the plug on the supply lead and the supply source
are earthed. This is a requirement for this type of
equipment and if not adhered to will contravene the
national and international standards of Health and
Safety in the work place.
WARNING
Risk of tipping
Follow the Safety Precautions.
The machine must be installed by an authorised
SCAN COIN representative.
Note
The machine must be protected by a fuse or a circuit breaker in the
electrical circuit.
Please also note the following when installing the machine:
• Operating temperature
15–35 °C
• Operating humidity
30–80% R.H
Do not place the machine close to any radiators. Make sure there is
some free space around the machine to allow the air to circulate.
The socket-outlet shall be installed near the equipment and shall be
easily accessible.
If the plug on the supply lead to the machine has a fuse, make sure
it has the correct rating in amps.
Use the supplied power cord at a properly grounded outlet.
The machine is exclusively for indoors usages, do not use it
outdoors.
Do not disassemble machine. If there are any problems with
operations, please contact the authorized distributor.
Do not exposes device to liquids, extreme humidity moisture.
Avoid operating device in environments with strong magnetic and
electromagnetic fields. For example, keep device away from
magnets, electrical appliances.
Although this machine has been tested and complies with the
national and international standards/regulations, it is recommended
that no equipment which generates a high level of electromagnetic
interference (EMI) or vibration is placed close to the machine.
Positional References
Unless stated otherwise, positions and directions such as left, right,
upper, lower, rear, clockwise and counter-clockwise are given with
respect to the machine when viewed from the front.
