AccuPro-5000
™
MEASUREMENT SYSTEM OPERATOR MANUAL
Issued by Department:
Engineering
Doc. Number:
5000-00-00-002
Revision:
02
Effective Date:
10/05/2021
File: 5000-00-00-002-r2_
AccuPro_5000_Operator_Manual
Copyright© 2021 Scaletron Industries, Ltd
All Rights Reserved
Page
31
of
63
Table 9: Operational Menu Tree
SYSTEM MODES
→
RUN MODE
SETUP MODES
(1)
SYSTEM MENU OPTIONS
USER
FACTORY
Scale Display
X
X
X
Alerts / Alarms
(2)
X
X
X
Dead Weight
X
Calibrate Weight
Set Units
X
Set Value (x4)
X
Capacity Weight
Set Units
X
Set Value
X
System Config
Factory Restore
(3)
X
Set Secure Tare
X
X
Set Keypress Buzzer
X
X
Set Alarm Buzzer
X
X
Set LCD Backlight Intensity
X
X
Configure Serial Out Port
X
X
Channel Config
Factory Restore
(3)
X
Set Measurement Units
X
X
Set Decimal Places
X
X
Set Sample #/Average
X
X
Set Bar-Graph
X
X
Liquid Mass
(4)
Set Density or Specific Gravity
X
X
Set Density Units
X
X
Set Liquid Mass Value
X
X
Tare Adjust
Set Units
X
(5)
X
X
Set Value
X
(5)
X
X
Relay Setpoint
(6)
Select Relay #
X
X
Set Status
X
X
Set Units
X
X
Set Setpoint Value (x2, x4)
X
X
Set Limit High or Low (x2, x4)
X
X
Set Mode Free-Run or Latching (x2, x4)
X
X
Set Audible Alarm
(7)
(x2, x4)
X
X
mA/V Output
(8)
mA/Volts-Output Calibration (x2)
X
Set mA/V Setpoints (x2)
X
X
Real-Time Clock
Set Time
X
X
Set Date
X
X
Set Trim Value (Oscillator Calibration)
X
About
Software Version #(s)
X
X
Current Time/Date
X
X
Current System Mode
X
X
NOTES: (1) If User or Factory Setup Mode not properly configured, the system defaults to Run Mode
(2) Option available only if an Alert/Alarm condition has been detected
(3) Option available only if Factory configuration was previously saved into non-volatile memory
(4)
Option available only if a “Volume” display unit is selected for an active channel
(5) Applicable only if Secure Tare is disabled
(6) Option available only if a Dual/Quad Relay Output Board is detected
(7) Option available only if a Latching Mode was enabled
(8) Option available only if a mA/V Analog Output Board is detected
