Radio System for use with 2.4GHZ RailBoss R/C
Channel Assignments
Rx
Left Stick
Up/Down Direction
Fwd/Rev
Elevator
ELEV
Left Stick
Left/Right Sound
Bell/Whistle
Rudder
RUDD
Right Stick Up/Down Speed
0 to 100%
Throttle
THRO
Right Stick Left/Right Momentum Off/On
Aileron
AILE
Mode 2 (Throttle on Left)
Left Stick
Up/Down Speed
0 to 100%
Throttle
THRO
Left Stick
Left/Right Momentum Off/On
Rudder
RUDD
Right Stick Up/Down Direction
Fwd/Rev
Elevator
ELEV
Right Stick Left/Right Sound
Bell/Whistle
Aileron
AILE
Mode 1 (Throttle on Right)
Parts Numbers
Transmitters
DX5e
5-Ch
DX4e
4-Channel
MLP4DSM
4-Channel
Spektrum Receivers
AR500
5-Channel
DSM2 Compatible Receivers
Orange Rx
6-Channel
DX6i
6-Channel
AR-6100 6-Ch
Notes:
1) RailBoss will work with 4 channels, but for two train operation you
need 5 channels.
2) Receivers featuring the “SmartSafe” failsafe are not compatible with
the RailBoss (AR600, AR6310, AR6100, and others. During loss of TX
signal, the receiver elevator channel must stop sending pulses (no
output, zero volts).
Trim Adjustments should be in the center position at all times.
(See Spektrum Tx manual)
Set all Servo Reverser switches to the Normal (down) position.
Set the Hi/Lo Rate switch to HI.
Recommended Radio System:
Purchase a Spektrum DX5e Transmitter (only) from your local hobby
shop or on-line (about $69).
Purchase DSM2 compatible receivers from G-Scale Graphics to in-
sure compatibility and get the lowest cost (about $15).
