Scag Power Equipment Tiger Cat II STCII-48V-22FX, Руководство оператора

Страница: 36 / 90

30
R
Section 6
1 2
34
A
B
1 2
3 4
A
B
Custom-Cut Baffle Adjustment
Mounting Slot Selected Mounting Hardware Location
Slot “A” Hole 1 Hole 2 Hole 3 Hole 4
Height (inches) 3-3/4” 4-1/4” 4-3/4” 5-1/4”
Slot “B” Hole 2 Hole 3 Hole 4
Height (inches)
3-1/2” 4” 4-1/2”
Figure 6-9. 7-Position Custom-Cut Baffle Adjustment
6.8 ELECTRIC CLUTCH ADJUSTMENT
The electric clutch serves two functions in the operation of
the mower. In addition to starting and stopping the power
flow to the cutter blades, the clutch also acts as a brake to
assist in stopping blade rotation when the PTO is switched
off or the operator presence circuit is interrupted.
When the clutch is disengaged, the air gap between the
armature and rotor must be adjusted to fifteen thousandths
of an inch, 0.015, for proper operation. The airgap
adjustment is made at three bolts on the clutch. There are
three inspection windows, one next to each adjusting bolt.
See Figure 6-10.
INSPECTION WINDOW (x3)
Figure 6-10. Clutch Air Gap Adjustment
1. Locate the inspection windows on the clutch.
2. Place a 0.015 feeler gauge in the slot between the
rotor and the armature. See Figure 6-11.
INSERT 0.015 FEELER GAUGE HERE
Figure 6-11. Clutch Air Gap Adjustment
3. Tighten or loosen the adjusting bolt as needed to
achieve the 0.015 inch airgap. See Figure 6-12.
Perform this operation at all three inspection
windows.