EKINOX Series
– Hardware Manual
EKINOXV3HM.1.2
3. Mechanical specifications
3.1. Overview
The Ekinox enclosure is composed of two anodized aluminum parts, one for the cover and one for the base
plate. The device uses high quality alloys and connectors to offer a full IP-68 enclosure and a good
resistance to harsh environments.
The cover part is made of 6061 aluminum alloy for its resistance to both seawater and industrial chemical
environments. In addition, this material offers a nice visual aspect.
The base plate is made of 7075 aluminum alloy to ensure best durability and accuracy. Indeed, this alloy
offers an incredible mechanical strength to guarantee the base plate integrity and accuracy during device
installation.
The cover and base plates are sealed together by four M3 stainless steel A4 screws (3016L). The Ekinox
should be installed to the host interface using four M4 stainless steel A4 screws.
The Ekinox connectors are high quality Fischer connectors that offers IP-68 protection even unconnected.
The Ekinox-D also include TNC connectors to plug the GPS antennas.
Warning: The Ekinox surface model is not designed for prolonged operation in salt water
environments. Check section Maintenance for more details about operation in sea water
environments.
3.1.1. Main Specifications
The table below summarizes all mechanical and environmental specifications.
Mechanical Specifications
A / E
D
Height
5.8 cm (2,28”)
7.5 cm (2.9”)
Width
10 cm (3,94”)
10 cm (3,94”)
Depth
8.6 cm (3,39”)
8.6 cm (3,39”)
Weight
435 g (1.0 lb)
610 g (1.3 lb)
Shocks
500 g for 0.3 ms
Operating Vibrations
3g RMS – 20Hz to 2 kHz as per MIL-STD-810G (A2 range options)
8g RMS – 20Hz to 2 kHz as per MIL-STD-810G (A3 range options)
Environmental Specifications
Enclosure
Anodized Aluminum
IP rating
IP-68 (24 hours at 2 meters)
Operating temperature
-40 to 75°C (-40 to 167°F)
Storage
-40 to 85°C (-40 to 185°F)
Humidity
Sealed, no limit
MTBF (computed)
50.000 hours
Calibration interval
None required, maintenance free
13/46
