www.saxbylighting.com
Instruction manual
75930, 75931
Bianco LED Wall
V5 28/02/2022
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
UK Manufacturer: BH17 7BY
Technical data
PIR Adjustment for 75931
220-240 V~, 50 Hz
Supply
Voltage:
Bulb
Type:
7W LED module (SMD), 3000K. This product contains a light source of energy efficiency class
F
.
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before cleaning.
Care and Safety
Conformity with all relevant EC Directive requirements.
Conformity with all relevant UKCA Directive requirements.
The power supply is Double Insulated and does not require connection to an Earth circuit.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is rated at IP44.
IP
44
This product is not suitable for dimming.
For further information, please visit
https://www.lighting-info.co.uk/75930
• The unit must be installed in a vertical position and the
optimum mounting height is 1.5m-2m above the ground
• The detection angle is set at 90 degrees. The duration
that the lamp stays on can be altered from 10 seconds
(± 5 seconds) - 4 minutes(± 1 minute). Use a small
screwdriver to adjust the ‘TIME’ and ‘LUX’ screws.
To access the adjustment screws flip down the cover over
the PIR sensor.
7m max. range
7M
7M
Top of sensor
LUX
TIME
LUX
TIME
Duration the bulb stays on is adjustable
by turning the 'TIME' screw. The sensor
trigger point is adjustable by turning the
‘LUX’ screw. 10Lux - daylight adjustable.
Replaceable (LED only) light
source by a professional
Replaceable control gear by a
professional
This LED Module is protected by a shade. This part must be replaced immediately should the shade
become cracked or damaged. This fitting must not be used without the shade in place.
Replace cracked shade
