Sawyer Manufacturing Company
7799 S. Regency Dr., Tulsa, OK 74131 USA
F
918.834.0318
P
918.834.2550
sawyermfg.com
V1.2
5
. Re-insert tension pin clip.
(O, Fig 7)
6
. To tighten, turn tape roll in-between left wing
(I)
and right wing
(A)
using tape tension knob.
(G, Fig. 8)
7
. Adjust take-up wheels
(B)
to same width as tape roll.
(N, Fig. 9)
Note: Use 1/8” allen wrench. (Fig. 9)
8
. Peel back tape roll film and place film onto take-up wheels.
(Fig. 10)
Note: Use tape to keep film in place, recommend cutting off a piece
of tape for each take-up wheel. (Fig. 11)
9
. Turn take-up knob to start rolling film free from tape.
(Fig. 12)
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
O
A
G
I
Installation
Note: Cigarette Wrap- Set machine on flat surface, loosen lap angle wing
nut (J), see that all four wheels are setting on the flat surface. Tighten lap
angle wing nut (J).
Note: Spiral Wrap- Loosen lap angle wing nut (J), raise wheel nearest the
lap angle wing nut (J) as required. The higher the wheel the greater the
lap, tighten lap angle wing nut (J). This is a trial and error adjustment
and will vary with different pipe sizes.
