58
This parameter purpose is to prevent
unprofessional operator to set other parameters wrongly.
1 way:
Retype password in the original parameter (if you don’t enter the original password it means you will
change it be sure to write down the original password)
2 way:restart the AC drive, Password protection immediately restore the default .
3 way:in the 13-00 enter one false password (Parameter 13-
00 will show “-End-“ ,no matter enter the password
correctly or falsely)
13-01
In the 13-00,enter the
correct password,13-01
will show “0”
13-00
correct
13-01
False password
13-01
You only have four opportunities to enter password.
when the 1
st
time enter the false password, the
monitor will shows 1.
when the 2
nd
time enter the false password, the
monitor will shows 2.
when the 3
rd
time enter the false password, the
monitor will shows 3.
when the 4
th
time enter the false password, the
monitor will blink and show ”codEr”
If you enter false password for 4 times,
keypad’s
monitor will be locked, the power must be rebooted,
then you can enter the password.
In the 13-00,enter the
correct password,13-01
will show “0”
14 Factory Parameters
14-06
Keypad test parameters(manufacturer)
Factory setting
0
Setting range
0 :No function
1:Keypad monitor fully display 8
This parameter is used to detect keypad LED monitor is damaged or not.
14-07
Software version
Factory setting
*****
Setting range 0~65535
This parameter is DSP software version number, set by the manufacturer.
