MW-1000™ User Guide
37
Logging
7.
How can I retrieve logs from MW-1000?
Refer section 6.3 'Copying the System Message Logs' for log-file details & their location on
MW-1000. For instructions on copying files between MW-1000 and local-PC, refer to the
following sections:
Windows environment (local-PC): Section - 9.1.1 'Winscp
–
Copying files from OBU
to/from local-machine'
Linux environment (local-PC): Use scp command to transfer files to/from MW-1000 and
local-PC
8.
Where does BSMlogs gets stored in MW-1000 board?
Refer section 6.3 'Copying the System Message Logs' for log-file details & their location on MW-
1000
9.
Where can I see my log files?
Refer section 6.3 'Copying the System Message Logs' for log-file details & their location on MW-
1000
10.
Can I get log files of more than 1-week old?
Logging duration depends on a host of parameters (configured/environmental). For example,
SD/EM memory-size, partition/disk-space, number of messages received, application logging-
priorities, etc
In typical scenarios, we observe MW-1000 to retain 1-week worth logs.
11.
Does logging gets stopped once MW-1000 disc-size is full?
No, Logging is not fully-disabled on Disc-full scenarios.
MW-1000 disables low-priority application logging on reaching the disc-threshold
(Application list is configurable)
MW-1000 continues logging of critical applications, but over-writes the old-logs with
new set of logs.
Refer to section 6.6 'System Message Logging (SML) Configuration' for updating logging-
preferences.
Note: Typically logging application starts controlling logging once it detects 70% disc-
utilization. (to avoid adverse impact on MW-1000 runtime application behavior)
12.
How can I disable logging of some applications?
Only BSM/Syslogs/Pcap logs can be enabled/disabled at this stage. Refer to section 6.4
‘
MW-
1000™ Messaging layer Configuration’
, topic
‘
Logging Configuration Items
’ for
configuration
parameter and their details.
Software Update
13.
Will my user-credentials get reset on upgrade?
Yes. Your MW-1000's user-credentials will get reset to factory settings (default user-
name/password) on upgrading with clean or network option to a newer version of MW-1000
image.
