MW-1000™ User Guide
19
rsn_pairwise
CCMP
This controls wpa2's data encryption First,
scratch macaddr_acl and
ignore_broadcast_ssid from your priorities
as they only enhance security.
By default, wifi0 interface is configured with IP address 192.168.102.1
The IP for the WiFi interface can be configured in /etc/init.d/savari-hmi, followed by a board reset.
HMI should be configured in the same network to communicate with MW-1000.
6.3 Advanced Configurations -
Messaging layer
BSM related parameters can be configured manually in the following file:
/etc/config/v2vi_obe.conf
This configuration file is self-describing. Each parameter has its description, range and default
value.
Note
: After modifying the file, the system needs to be rebooted (using the “reboot” command) or
an application process stop/start is needed for the modifications to take effect.
The following are the BSM parameters:
MW-1000™
Configuration Items
:
This table includes the important
MW-1000™
configuration parameters.
Parameter
Value
Range
Description
EnableTxRx
3
0,3
0: Disable both Tx and Rx
1: Tx only enabled
2: Rx only enabled
3: Tx and Rx enabled
802.3 Configuration Items:
Parameter
Value
Range
Description
TxPwrLevel_dBm
23
0 – 33
Valid values: 0 to 33 in increments of 1
dBm.
TxDataRate_Mbps
12
6 – 54
Configuration parameter is twice the actual
10 MHz channel rate (i.e., 12=6Mbps)
Configuration parameter is the actual 20
MHz channel rate (i.e., 12=12Mbps)
Valid values: 6, 9, 12, 18, 24, 36, 48, 54
AC_BE_CWminKVal
4
1 – 10
CWmin = 2k - 1
