Savant SmartLighting, Примечание к применению

Страница: 4 / 22

Summary of Conversion
The steps outlined in the next table should be performed in the sequence shown to complete a
conversion of a LiteTouch system to a Savant SmartLighting system. Some of these steps have hyperlinks
to more detailed procedures. Click the hyperlinks to see those procedures.
Step Procedure Details
✓
1
Access the LiteWare ® *.prg file, which is required
for upload to the Savant SmartLighting controller.
Ensure you have the correct files.
2
Shut down all power to the legacy system from the
CCU and main breaker panel.
3
Remove power supply control modules from the
module enclosures.
4
Remove legacy transorb boards and replace with
Savant transorb boards.
5 Install SmartLighting controller.
6 Install Savant Keypad Links.
7
Confirm the rewiring as follows:
• New transorb board connected to
SmartLighting controller via Cat 5/5e/6
cable.
• New transorb board connected to new
transorb board in precise reflection of the
legacy LiteTouch system.
• First control module connected to the
transorb board within each module
enclosure.
• Power to the SmartLighting controller
connected via electrical outlet to SKL-1000
or breaker feed to SKL-4000.
• Station ports from SmartLighting controller
connected to Savant Keypad Link.
• Savant keypad links to other Savant keypad
links connected via Cat 5/5e/6 cable.
• Keypad wire bus connected to Savant
keypad links.
8 Turn on power to SmartLighting system.
9 Export *.prg file to SmartLighting controller.
140915 009-0885-01 Savant SmartLighting Control Conversion Application
4 of 22