SHA-B6xx-00 | 009-1650-01 | 180530
Copyright 2018 Savant Systems, LLC
45 Perseverance Way, Hyannis, MA 02601
| 508.683.2500
1 of 2
HELPFUL!
Before starting the mounting process, review the Horizontal and Vertical mount diagrams below to ensure a trouble free install.
When mounted, the Shade Double Drive mount allows for a shade motor to be installed on both sides. A typical installation would have the dou-
ble drive mount installed in the middle of a wide window. In this installation, the shades on either side are driven independent of each other. The
SHA-B6xx shade mount can be used with both the floating/outside type and inside/jamb type shade mounts and is installed using the included
shade mount sleeve and 2 inch hanger bolt. The SHA-B6xx should be the first mount installed and once it is mounted, it can then be used as a
reference for mounting the idler side mounts.
Horizontal Mount
Vertical Mount
1.75 in.
(minimum)
1.75 in.
(minimum)
– Install the SHA-B6xx so the center point of the
coupler is installed at least
1
³/₄
inch (minimum)
from any obstructions.
– To aid in the installation of the shade mounts,
a template (SHA-INSTEMP-xx) is available. This
template contains all the holes and spacing re-
quired to mount any of the shade mounts.
– To reduce marking up the walls, it is recommend-
ed that painters tape be used whenever drilling
is involved.
Box Contents
(1) Shade Mount - Floating Outside Double Drive Mount
(1) 2-inch Hanger Bolt
(1) 1 inch Shade Mount Sleeve
(1) #6 x 1
1/2
in. Flat Head Screw
(2) Silver Aluminum Shade Motor Replacement Covers (B6SA versions only)
(1) Quick Reference Guide (this document)
Note:
Additional documentation on installing this shade mount as well as
information on all phases of shade installation, is available on the
Savant Cus-
tomer Community
.
– Shade Installation and Wiring Guide (009-1532-xx)
Hanger Bolt
Shade Mount Sleeve
3/32 in. Hex Screw
Shade Mount
Front View
Side View
Shade Motor
Replacement Cover
3/8 in.
1/2 in.
Drill Hole through
the coupler mount
To Wires
In Wall
To Wires
In Wall
Mounting Instructions
1.
Mark the wall or ceiling where the hanger bolt will be mounted. Ensure the following:
– The center point of the mount must be at least 1
3/4
inches from any obstructions.
Refer to
Horizontal
and
Vertical
mount diagrams above.
– When installing, the mount should be positioned so the control and power wires for
each motor exiting the wall/ceiling will exit near the hole that will be drilled in step 3
below.
2.
Place the mount on the wall where it will be installed. With a pencil, scribe a mark on the
mount in the general location where the hole for the control and power wires in step 3
below will be drilled.
HELPFUL!
For reference of where the wires should exit the wall, see the diagrams to the
right.
3.
Using the general area selected in step 2 above, measure down from the top edge of the
mount
3/8
inch and measure over
1/2
inch from rear edge of mount and scribe a mark. On
the mark made, drill an
11/32
inch hole so it goes through both sides of the coupler.
4.
Feed the control and power wires for each shade motor through the hole just drilled,
and out the rear of the mount (Wires for each motor should be fed through hole on both
sides of the shade mount). Refer to diagrams to the right.
For Product Info
Savant® Shade Double Drive (SHA-B6xx-00)
Quick Reference Guide
