Sauter flexotron®800
ventilation
Commissioning
P100012082
29
4
Commissioning
4.1
General
Before the controller flexotron®800 can be used it must be configured, inputs and
outputs must be assigned and all relevant parameters must be set.
All commissioning can be done using the flexotron®800 front panel display and buttons
or using the display unit RDB800.
CASE flexotron®
The best way however, is to configure the regulator by using CASE flexotron®
CASE flexotron® is a PC-based configuration program specially developed to simplify
the commissioning of the flexotron®800 series.
When using CASE flexotron® the whole configuration and all settings can be done on
the computer and then be downloaded to the flexotron® 800. An infinite number of
different configurations can be saved in computer memory for later use.
A communication cable is required in order to configure flexotron®800 with CASE
flexotron®.
The controller flexotron®800 must be powered up and the application selected in order
for it to be configured.
4.2
How to do it
For configuration using CASE flexotron®, see the CASE flexotron® manual.
For configuration using the front panel there are two ways to go depending on how
much help you need.
4.2.1
Option 1:
Jump straight to chapter 7 and 8,
Display, LEDs and buttons
and
Access rights
.
After learning how to use the buttons and menu system, connect power to your
controller, log on as Admin and go to the menu "Configuration".
For the time being, skip the configuration menu In-/Outputs and start by
configuring control functions.
Run through the configuration menus in order and set whatever functions and
parameters you wish to include. Use chapter 6 of this manual for reference.
Keep track of which inputs and outputs you will need. To help you, there is a list
of input and output functions provided in chapter 3, (3.2.3 Input / Output list.)
Finally, configure In-/Outputs.
Exit the "Configuration" menu and go to "Settings".
Set the control values in "Settings".
Set the clock and scheduler functions in "Time Settings".
Set the control setpoints in temperature and air control as well as in humidity
control if humidity control has been configured
Your controller flexotron®800 should now be ready to run.
4.2.2
Option 2:
Read this manual in the order given below: The manual has been designed to act as a
guide through the commissioning. The last chapters of the manual, not listed below,
cover menus and functions that are not used during commissioning.
Functional description
Start by reading chapter 5
.
Functional description
below. Some functions are essential
to the working of the unit and must be included. Others are more of the nature of
optional extras which can be excluded.
