45.016/6
LRA4
**
Sauter Components
wireless room operating unit
P-42
Compensate for the floor temperature
0
P-43
Specify the maximum value for the floor temperature
35 °C
P-44
Specify the setback temperature for the 'Eco' function
3 K
P-45
Activate or deactivate the cooling lock and/or bypass, e.g. for a
heat pump
0
P-46
Activate or deactivate the 'Make common use of a setpoint
within a zone' function
0: deactivated
P-47
Activate the lock for public buildings or hotels
0: deactivated
P-48
Activate or deactivate the master function for a wireless room
operating unit
0: deactivated
P-49
Specify the function of the external temperature sensor. An
optional external temperature sensor must be connected to
the wireless room operating unit
0
Parameters that are specific to the installation and the topology
Factory setting
P-51
Set priorities for the 'heating/cooling' change-over and for the
'heating/cooling' output or burner control
0
P-52
Activate or deactivate the 'Optimised time programme' function 0: deactivated
P-53
Set the type of communication between wireless controllers
(options: radio or bus)
0
Control parameters
Factory setting
P-61
Configure ECO or N/R input
0
P-62
Configure c/o in or temp. limit input
2
P-63
Select 'local' pump activation or activation through the 'master
wireless controller' (only for communication between wireless
controllers)
0
P-64
Select function NC or NO for thermal actuators
0: NC
P-65
Select control algorithm
0: ON/OFF
P-66
Activate the 'Optimised actuator control' function
0: deaktiviert
P-67
Select the initial controlled floor heating
0: deaktiviert
Dimension drawing
7145016003 01
