sauermann SI-CA 320, Руководство пользователя

Страница: 23 / 144

23
9.1
Configuration
→
Analysis
PARAMETER DESCRIPTION
Allow choice of fuel to be used for the analysis phase. This data can be modified, not only through the menu, but
also during the analysis phase.
By selecting the
Fuel Coefficients
submenu, you can display the characteristics of the fuels used to calculate the
efficiency.
SEE CHAPTER 9.1.1.
Condensation efficiency is influenced by atmospheric pressure and humidity of the combustion air. Since the
atmospheric pressure is generally not known, the verifier of the thermal systems is asked to enter sea level altitude:
working from this altitude, the instrument calculates the pressure without taking into account the meteorological
conditions
The calculation assumes an atmospheric pressure at sea level of 101325 Pa. It is also possible to enter the relative
humidity of the air, deemed the combustion air temperature measured by the instrument; if it is not known, it is
recommended to enter 50%.
SEE CHAPTER 9.1.2.
It is possible to regulate the percentage of oxygen in this mode. This will be used when displaying the values of
pollutant gas emissions encountered during the analysis.
SEE CHAPTER 9.1.3.
NOx/NO
: all nitrogen oxides present in chimney emissions (Nitrogen oxide = NO, Nitrogen dioxide = NO
2
); total
nitrogen oxides =
NOx (NO +
NO
2
)
.
In combustion processes it can be seen that the percentage of NO
2
present in the flue gases never differs from very
low values (3%). This makes it possible to obtain the NOx evaluation by a simple calculation without having to use
a direct measurement that would require the presence of an NO
2
sensor.
The value of the percentage of NO
2
present in the fumes can be set at a value other than 3% (default value).
SEE CHAPTER 9.1.4 .
In the submenu it is possible to modify the Measure units for all analysis parameters in accordance with the usage
requirements.
SEE CHAPTER 9.1.5.
In this submenu you can modify the duration of the analyser autozero cycle and start it manually.
SEE CHAPTER 9.1.6.
In this submenu, it is possible to display the Measures list carried out by the instrument. Using the interactive keys,
it is possible to add, delete, or move a selected measurement by position.
SEE CHAPTER 9.1.7.
In the submenu, it is possible to read or manually enter the temperature of the combustion air.
SEE CHAPTER 9.1.8.
CONTEXT KEY FUNCTION
◄
Select the available parameters.
OK
Enter the selected parameter.
►
Select the available parameters.
15/01/14
10:00
Analysis
configuration
Fuel Condensation
Reference O
2
NO
x
/NO report
Measure units
Autozero
Measures list
Air temp.
KEY FUNCTION
Enables the displayed interactive operations.
Return to the previous page.
Fuel
Fuel
O2 reference
O
2
reference
NOx/NO report
Measure units
Autozero
Measures list
Air temperature
Autozero