Page 7 of 7
STEP 8
Use the four remaining
12mm Aluminum Screws
to secure the top plate. Please be careful
tightening these as you are screwing into the 3D Print and may damage the mount if
overtightened. It should look like an elegant, immaculate creation when you are done!
Sit back, relax and grab a beer because you just assembled your first (definitely not your last)
Saturn Multi Rotors Titan-X 225.
Now take some pictures, post them to our group
- here
, then remove the top section and get to
mounting your components!
If you needed this log to convince you to purchase one of these bad boys then here is a direct
link back to the
Titan
- here
